Volvo 2007 S80 - Manual (Page 207)

06 Maintenance and specifications
206
Wheels and tyres
06
12.Switch off the compressor and unplug
the cable from the 12 V socket.
13.Detach the hose from the tyre valve and
fit the valve cap.
14.As soon as possible drive
approximately 3 km at a maximum
speed of 80 km/h so that the sealing
fluid can seal the tyre.
Rechecking the repair and pressure
1. Reconnect the equipment.
2. Read the tyre pressure on the pressure
gauge.
• If it is below 1.3 bar then the tyre is
insufficiently sealed. The journey should
not be continued. Contact a tyre centre.
• If the tyre pressure is higher than 1.3 bar,
the tyre must be inflated to the pressure
specified on the tyre pressure decal. Re-
lease air using the pressure reducing valve
if the tyre pressure is too high.
3. Switch off the compressor. Detach the
air hose and cable.Refit the dust cap.
4. Return the emergency puncture repair
kit to the cargo area.
Drive to the nearest authorised Volvo work-
shop to replace the damaged tyre. Advise
the workshop that the tyre contains sealing
fluid.
Replacing the sealing fluid canister
5. Replace the bottle when the expiration
date has passed. Treat the old bottle as
environmentally hazardous waste.
WARNING
If the pressure is below 1.8 bar then the
hole in the tyre is too big. The journey
should not be continued. Contact an au-
thorised tyre centre.
NOTE
To avoid splashes, leave the bottle in its
holder.
NOTE
The sealing fluid bottle and hose must be
replaced after use. Replacement must be
performed by an authorised Volvo work-
shop.
WARNING
Check the tyre pressure regularly.
WARNING
You should not drive faster than 80 km/h
after the emergency puncture repair kit has
been used. The temporarily sealed tyre
must be changed as soon as possible (max-
imum driving distance: 200 km).
IMPORTANT
Read the safety instructions on the bottom
of the bottle.