Vestax PMC 250 - Manual (Page 4)

3
15. Damage Requiring Service-Unplug this product
from the wall outlet and refer servicing to
qualified service personnel under the following
conditions:
a. When the power-supply cord or plug is
damaged.
b. If liquid has been spilled or objects have fallen
into the product.
c. If the product has been exposed to rain or
water.
d. If the product dose not operate normally by
following the operating instructions. Adjust
only those controls that are coverd by the
operating instructions as an improper
adjustment of other, controls may result in
damage and will often require extensive work
by a qualified technician to restore the product
to its normal operation.
e. If the product has been dropped or cabinet has
been damaged.
f. When the product exhibits a distinct change in
performance this indicates need for service.
16. Replacement Parts-When replacement parts are
required, be sure the service technician has used
replacement parts specified by the manufacturer
or have the same characteristics as the original
parts. Unauthorized substitutions may result in
fire, electric shock or other hazards.
17. Safety Check-Upon completion of any service or
repairs to product, ask the service technician to
perform safety checks to determine that the
product is in proper operating condition.
18. Carts and Stands-The appliance should be used
only with a cart stand that is recommended by
manufacturer.
19. An appliance and cart combination should be
moved with care. Quick stops, excessive force,
and uneven surfaces may cause the appliance
and cart combination to overturn.
F E A T U R E S
1. Three-band frequency isolators are provided
o n P G M 1 a n d P G M 2 . Th i s a l l ow s D J s t o
boost / cut and eliminate individual frequency
ranges for active mixing.
2. The worlds first fader-type kill switch enables
smooth and dynamic frequency cut-off without
clicking noise.
3. The I/O panel can be placed on either the rear or
top side. This feature enables the PMC-250 to be
used on the table or in a rack without any extra
space for the leads.
4. Both the input faders 60 mm and cross fader
45 mm are user replaceable. The input fader can
be replaced with a rotary control for House
applications.
5. One Phono and two Line inputs are provided on
each program channel PGM1, PGM2 . Each
input channel has a trim control for adjusting
input level. A Phono / Line selectable AUX input
and a Mic input are also provided.