Vantec UGT-PC302 - Manual (Page 6)

UGT-PC302
Page 6
New Hardware Wizard'.
2. Cancel the automatic driver installation and run the
Setup.exe located on the Driver CD.
Note: Setup.exe can also be found and downloaded
from our website at www.vantecusa.com .
3. Run installer setup.exe on Driver CD “X:\UGT-PC302\” to
have the latest driver for 32/64bit Windows. (where X is the
drive path for your CD-ROM drive)
4. When installation of the driver is complete, please reboot
the system as prompted to complete the driver installation.
Note: When drivers have been successfully installed,
you may check if installation was successful within the
Device Manager where “NEC Electronics USB 3.0
Host Controller” will be shown.