Vector MAXX SST VEC049C - Manual (Page 2)

IMPORTANT SAFETY INFORMATION
To ensure reliable service, your power inverter must be installed and used
properly. Please read the installation and operating instructions thoroughly prior
to installation and use. Pay particular attention to the WARNING and CAUTION
statements in this manual. The CAUTION statements advise against certain
conditions and practices that may result in damage to your inverter. The WARNING
statements identify conditions or practices that may result in personal injury.
READ ALL INSTRUCTIONS BEFORE USING THIS POWER INVERTER
WARNINGS
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, EXPLOSION OR INJURY:
• Do not connect to AC distribution wiring
• Remove appliance plug from outlet strip or turn off inverter before
working on the appliance
• DO NOT place inverters in an area, room or compartment where
explosive or flammable fumes might be present
• Using power strips, with switches and circuit breakers, only interrupt
power to the “hot” receptacle terminals. The “neutral” terminals remain
powered with respect to the “ground” terminals
• Always unplug appliances when servicing
• This is not a toy - keep away from children
CAUTIONS
•
NO USER-SERVICEABLE COMPONENTS INSIDE;
OPENING UNIT WILL VOID WARRANTY; TO SERVICE INVERTERS
CONTACT SERVICE DEPARTMENT AT (866) 584-5504
• Do not install in engine compartment - install in a well ventilated area
• Do not use with positive ground electrical systems (the majority of
modern automobiles, RVs, trucks and boats are negative ground)
• Reverse polarity connection will result in a blown fuse, may cause
permanent damage to the inverter and will void the warranty
• This inverter will not operate appliances or equipment that exceed
inverters maximum rating
• Grounding the Neutral will cause the inverter to shut down
• Do not operate this inverter if it is wet
• Not approved for use with medical equipment
IMPORTANT CABLE INFORMATION
Substantial power loss and reduced battery operating time results when inverters
are installed with cables that are not able to supply full power. Low
battery power can result from cables that are either excessively long or an
insufficient gauge. The installer/operator should be aware of all installation
requirements to maintain secure, electrical connections. Cable insulation and
ampacity must be the appropriate type for the environment. To purchase a prepared
cable and fuse set, contact Technical Support at (954) 584-4446 or
toll-free (866) 584-5504.