Viper Concept 550.2 - Manual (Page 10)

10
© 2002 Directed Electronics, Inc
Tweeter Surface Mounting
1. Determine the tweeter mounting
location, then route the wires from
the crossover to the tweeter loca-
tion.
2. Place the surface mount housing
against the panel and mark the two
holes at the rear of the housing.
3. Drill the smaller center hole using a
1/8" drill bit. This is the mounting
screw hole.
4. Drill the larger off-center hole using a
3/8" drill bit, insert a grommet and
route the speaker wire from the
crossover through the grommet.
5. After removing the surface mount
tweeter assembly trim ring, route
the tweeter wires through the larger
hole in the housing and connect to
the speaker wires from the
crossover. (See Figure 4.)
6. Insert the excess speaker wire into
the hole and position the housing so
the housing will not pinch the wires
after final mounting.
7. Attach the housing using the
supplied screws of the correct length
for a solid mount.
8. Insert the tweeter into the housing
and attach the trim ring.
FIGURE 4—TWEETER SURFACE MOUNTING