VXI Parrott CP100 - Manual (Page 2)

OPERATION
1. CONNECT HEADSET TO YOUR
CORDLESS OR MOBILE PHONE
For cordless or mobile phones with a compatible 2.5mm
jack. insert the 2.5mm plug directly into the headset jack
on the phone.
For mobile phones requiring an adapter, insert the 2.5mm
plug into the headset jack on the adapter.
COMPONENTS
1
8
6
2
3
4
5
7
1. Adjustable headband
2. T-Bar
4. Flexible microphone boom
5. Noise canceling microphone
6. 2.5mm connector
7. Express Disconnect
3. Receiver / ear cushion
8. Microphone boom swivels for left
or right side wear
TM
For customer assistance, please call VXI at 1-800-742-8588 or visit
our website at www.vxiparrott.com.
2. C HOOSE A SIDE FOR THE MICROPHONE
Determine which side of your head you would
prefer to locate the microphone. Swivel the
microphone boom as shown.
3. MICROPHONE ADJUSTMENT
Position the microphone so it is located one finger-width
from the corner of your mouth just below your bottom lip.
The microphone has the word TALK or a painted dot
printed on it (under the cushion). Be sure that this mark is
facing your mouth.
"TALK" or a painted dot
4. USING THE EXPRESS DISCONNECT
To quickly disconnect the headset from the lower cord, simply grasp both sides
of the Express Disconnect (avoid pulling on the cord) and
pull them apart.
To reconnect the headset to the lower cord again, take note of the markings on
either side of the connectors. Match up the markings
and push the two sides of the connector firmly together again.