Vizio C-CV454D-9 CU - Manual (Page 10)

10
Fit the waterproof cap
(shaded area) into place.
5. Attach the waterproof cap to the camera unit.
Note
If the waterproof cap is not secured to the mounting surface, water or moisture soaks in, causing the corrosion
of the BNC connector. This may cause unit failure. Check to be sure that the waterproof cap is secured as
shown below.
4. Connect the connector.
Connect the connector of the supplied cable with waterproof cap to the camera unit's video output terminal,
then tighten the lock screw of the connector.
Notes
• To meet the waterproof requirements, insert the connector in place until it will not go any further.
• Wrap self-adhesive butyl rubber tape around cable joints in order to prevent rain from soaking in.
Connector
(waterproof type)
Waterproof cap
Video output terminal
Supplied cable
Cable joints
UL 1095#22 Black/White (non-polar)
Connect to the monitor.
Connect to the AC mains.
BNC jack BNC plug
Lock screw