Vestax PMC 500 - Manual (Page 9)

REAR PANEL
$3MIC1 INPUT JACK
Input jack for MIC.
MIC1: PHONE JACK (UNBALANCED)
MIC2: XLR JACK (BALANCED)
$4 EFFECT LOOP JACK
TIP: SEND OUT
RING: RETURN INPUT
SLEEVE: EARTH
Connects to the input of an external effects device.
$5INPUT LEVEL SELECT SWITCH (0dB/-10dB)
Selects the attenuation level for any input signal.
$6LINE INPUT RCA JACK
Input connectors for line level equipment such as CD
players, MD players, tape decks, DAT and/or VTR
etc.
$7PHONO INPUT RCA JACK
Input jacks for turntables. Connect turntables
equipped with MM (pick up) cartridge.
$8GND TERMINAL
Connect this terminal to the ground lead of the
turntable. This will help to reduce unnecessary noise.
$9AUX SEND JACK
Connects to the input of external effects devices.
(Delay, Reverb, etc)
%0AUX RCV JACK
Connects to the output of external effects devices.
%1REC OUT JACK
Connects to the input jack of any recording device
IE, tape recorder, MD, DAT, etc. The output level of
this jack is fixed and does not change with the
MASTER LEVEL.
%2MASTER OUT1&2(1/4" PHONE JACK
(UNBALANCED),XLR JACK(BALANCED)
Connect to the input on a power amplifier. These jacks are
Phone type for consumer applications. This mixer has
two sets of MASTER OUT jacks so that the each output
level can be set separately. Therefore, the MASTER
OUT can be used for main output or sub output IE. One
for the main area and the other for entrance.
%3BOOTH OUT(1/4" PHONE JACK
(UNBALANCED),XLR JACK(BALANCED)
Connects to the DJ booth monitors.
%4POWER SWITCH
Power on/off.
%5POWER JACK
Connect the Vestax AC-20 , AC adaptor.