Verilux VF05-MAN-REV3 - Manual (Page 7)

3
ASSEMBLY INSTRUCTIONS
Before assembling, please review all instructions.
1. Carefully lay out all parts on fl at surface as shown in illustration.
2. Screw post (B) into the base (A) and hand tighten.
3. Screw post section (C) into post (B) and hand tighten.
4. Rotate shade (G) to right angle with body (E) and parallel to the
fl oor. Then, use the (included) Allen wrench (F) to carefully tighten
the screw.
5. Loosen the thumbscrew (D) to adjust the lamp height. Raise or
lower the lamp body (E) to the desired height and tighten the
thumbscrew (D).
6. Remove thumbscrew from Optix ® fi lter on lamp head and carefully
slide fi lter out of channel and place on clean surface (Fig. 1).
7. Remove the 27 W Natural Spectrum ® bulb from the packaging and
carefully insert it into the socket as demonstrated in Figure 2. Be
sure to hold the bulb by the base and ensure it is fully inserted into
the socket and clipped into the metal clip on both sides of bulb.
Note the telephone number on the bulb provides contact
information when reordering.
8. Slide Optix ® fi lter back into place and re-install thumbscrew (Do not
over tighten) Fig. 5.
9. Plug lamp into an appropriate outlet and turn on the switch.
10. Do not use with an extension cord or on a circuit with a dimmer
switch.
11. Save the packaging in case you need to send the lamp to Verilux for
servicing.