VIEWSONIC NEXTVISION N4 - Manual (Page 7)

4 ViewSonic NextVision N4
The Remote Control
Activate the Remote Control
The first time you use the remote control, activate the remote
control by pulling the plastic tab out of the remote control.
CAUTIONS
• An explosion may occur if you use the wrong battery! Use
only the type of battery recommended by the manufacturer
• Only use the specified 3V Lithium batteries
• Do not mix new and old batteries. This may result in
cracking or leakage, which may pose a risk of fire or lead to
personal injury
• Insert batteries according to (+) and (-) markings. Inserting
the batteries incorrectly may result in cracking or leakage,
which may pose a risk of fire or lead to personal injury
• Dispose of the battery in accordance with local laws and regulations
• Keep the battery away from children and pets
• When the remote control is not used for an extended period, remove the
batteries.
Note: Replace the batteries if the operation of the remote control becomes
irregular or weak
To change the battery
1. Push the tip of a ballpoint pen into the small pin hole on the back of the
remote control as shown below and pull the cover off.
2. Place the 3 V Lithium battery in the battery compartment.
Lithium battery
Back cover
Pin hole
N4 User Guide.book Page 4 Wednesday, March 5, 2003 10:07 AM