VocoPro DA-3700 - Manual (Page 10)

8
Vocals
The MIC INSERT jacks on the rear panel allow you to
loop the vocals through an effects unit. NOTE: In or-
der to do this you must have a 1/4” Y adapter cable
(not included) for each microphone line.
Connect the single end of the Y cable into the MIC
INSERT jack. Connect one side of the double end into
the input on the effects device and the other end into
the output of the effects device.
NOTE: If the Y cable is plugged into the DA-3700PRO
but the double ends are not connected to the IN and
OUT of a device, there will be no sound. So if you are
not using effects, be sure the Y cable is unplugged.
Using a mic cable with a 1/4” end, connect the mic
to either of the DA-3700PRO’s microphone inputs.
Effects Loop connections
Source Music (Music from a DVD or CD player)
By using the built-in Effects Loop you can add ef-
fects such as a professional Digital Key Controller
to the source player’s music without compromising
the quality of the original signal. To use the effects
loop connect an RCA cable from the DA-3700PRO’s
EFFECTS LOOP L or R OUT jack to the effects unit
input. Then connect an RCA cable from the effects
unit output, into the DA-3700’s L or R IN jack.
Connect the Remote Key Control cable into the KEY CONTROLLER jack on
the rear panel of the DA-3700PRO.
Mic(s) connection A mic with Remote Key Control
Getting connected (cont.)
Vovopro DKC-100
To IN To OUT To IN To OUT
To IN To OUT
Vocopro VSPM-1
T
NOTE: If you are not using the Effects Loop,
be sure the LOOP BARS are re-connected.
Without these, there will be no sound.
Y Adapter Cable