Venta Airwasher LW 44 - Manual (Page 15)

Replacement of gear and coupling
1 Place the rubber coupling into the locking ring so the rubber feet from the coupling
hang below the ring. When placing the coupling and ring on the center shaft of the
fan the rubber feet should line up with the notch marks on the fan.
2 Snap the ring and coupling into place.
3 With the gear laying on its side place it between the motor housing arms that
suspend it above the fan.
4 While placing the palms of your hands against the motor housing arms, apply slight
pressure, and pivot the gear to the operating (upright) position. Check that the
locking knob (flange) is properly seated. The locking knob, on either side of the
gear, should fit tightly behind the ridge of the motor housing suspension arm.
5 Insert the rubber coupling into the bottom of the gear and push it up into the gear
until it fits tight. On models with a small white pin, first insert the pin through the
rubber coupling and then push both up into the gear until it fits tight. Check that
this is properly seated by spinning the fan with your hand. The teeth in the gear
should slowly move in and out.
Service Option: Venta-Airwasher
In case you prefer the factory to handle your concern, for warranty repair, or if you
wish to utilize the factory cleaning service for your Venta-Airwasher, please call our
customer service department toll free at 1 (888) 333 8218 to obtain a Return
Merchandise Authorization (RMA) number. Attach a tag to the product that includes
your name, address, daytime phone number, and description of the problem. Include
a copy of the original sales receipt. For products purchased in the United States,
carefully package the product in its original packaging and send it either by UPS or
Parcel Post with shipping and insurance prepaid to:
Venta-Airwasher LLC • 1360 Hamilton Parkway • Itasca, Illinois 60143
15
1 2
3 5