Viking F20398A - Manual (Page 5)

9
E Elle eccttrro on niicc T Te em mp pe erraattu urre e S Se ettttiin ng gss
The electronic controls are located behind the refrigerator door above
the refrigerator section. Press
Display On pad to activate control
panel. All other pads except for Alarm Off pad, remain inactive until
Display On pad is pressed. Once activated, pads remain
programmable for at least 10 minutes.
Refrigerator and freezer controls are preset at the mid setting, (5 bars
are displayed). Wait 24 hours after connecting power for refrigerator
and freezer sections to reach this setting. After 24 hours, adjust
controls as desired. 1 bar displayed is the warmest setting and 9 bars
displayed is coldest setting.
•To adjust refrigerator or freezer temperature, press Display On pad
then Ref Temp pad or Freezer Temp pad. Press Higher Temp pad
or Lower Temp pad to adjust temperature setting 1 level at a time.
Holding down Higher Temp pad or Lower Temp pad adjusts
temperature more than 1 level at a time
E En nttrryy T To on ne e
Entry tone is the “beep” heard when a pad is pressed and command is
read and accepted.
•Deactivate entry tone by pressing and holding Display On pad for
3 to 5 seconds. Three short beeps indicate instructions were
accepted.
•Activate entry tone by pressing and holding Display On pad for 3
to 5 seconds.
M Maaxx R Re effrriig ge erraatto orr M Mo od de e
Max refrigerator mode adjusts refrigerator temperature to the coldest
setting for 10 hours. Then the refrigerator temperatures automatically
return to previous setting.
•Activate max refrigerator mode by pressing Display On pad then
Max Ref pad. Indicator light will glow.
•Deactivate max refrigerator mode before automatic reset by
pressing Display On pad then the Max Ref pad.
8
B Be effo orre e U Ussiin ng g Y Yo ou urr R Re effrriig ge erraatto orr
To obtain the best possible results from your refrigerator, it is important
that you operate it properly. This section tells you how to set the
temperature controls, how to operate the features in your refrigerator,
and how to save energy.
U Ussiin ng g tth he e p po ow we err o on n//o offff ssw wiittcch h ((p po ow we err iin ntte errrru up ptte err ssw wiittcch h))
The power on/off switch is located behind the top grille. It is used to
turn the power to the refrigerator off when cleaning it or changing the
light bulbs. The refrigerator is shipped with the power interrupter
switch on.
To turn power off:
1. Remove center grille blade.
2. Press power on/off switch to the OFF position.
To turn power on:
1. Press power on/off switch to the ON position.
2. Replace center grille blade.
IIM MP PO OR RT TA AN NT T:: Be sure the power on/off switch is in the ON position
after cleaning the refrigerator or changing light bulbs.
U Ussiin ng g tth he e ssh ho ow wrro oo om m ssw wiittcch h
The showroom switch allows electronic controls and interior lights to
function independently of refrigeration system. Showroom switch is
located behind the top grille to the right of the control panel. The
refrigerator is shipped with the showroom switch in the run position.
Showroom switch
on - full cooling
power to
refrigerator.
Showroom switch
off - no cooling in
refrigerator (power
only to lights and
electronic controls).
Showroom
switch
Power
switch