VocoPro SUB-1200 - Manual (Page 9)

Getting Connected
Connecting to an amplifier with no pre-amp outputs
If no low-level Pre-Amp outputs are available, you need to run speaker cables from your main amplifier to the
Sub-1200. Run the main LEFT and RIGHT speaker cables to the Sub-1200 HI-LEVEL IN binding posts. Be sure
to double check that the polarity (-/+) on the receiver or amplifier matches the polarity on the binding posts of the
SUB-1200. Also, make sure that the outputs on your main amplifier are true ground, otherwise you would short
the output of your main amplifier. Call or email technical support if the outputs on your main amplifier do not have
true ground.
WWW.VOCOPRO.COM LA VERNE CALIFORNIA U.S.A.
! CAUTION
RISK OF ELECTRICAL SHOCK DO NOT OPEN
115V
230V
OFF
0 PHASE 180
POWER
AUTO
LEVEL LINE OUT LINE IN CROSSOVER
FREQUENCY
ON
R
L
+ + - - LEFT RIGHT HI LEVEL IN
+ + - - LEFT RIGHT HI LEVEL OUT
AMP
HI-LEVEL IN LEFT SPEAKER OUT LEFT
SPEAKER OUT RIGHT HI-LEVEL IN RIGHT
Connect to speakers
8