Varimixer J - Manual (Page 10)

The planetary head is removed in the following way:
a) The top cover of the mixer (1), the attachment engagement hub (3), the special V-belt (7), and the control box (6)
are removed.
b) The plastic ring (26) can be removed by knocking it gently on the front edge, then pressing a screwdriver between
the plastic ring and the metal plate at the top of the plastic ring.
c) Remove the rubber ring (27).
d) The stainless headcap (28) can now be removed by knocking it gently on the front edge with a plastic hammer,
turning the planetary head 1800, and again knocking gently on the front edge.
e) If only the lower part of the planetary head is to be repaired, the planetary head can be separated by removing
the 3 bolts (29).
f) Remove the grease nipple and washer (30), and pull off the upper half of the pulley set (31) with an extrac-
tor.
g) Take off the movable part (32) of the pulley set. h) Take off the 4 screws (33).
h) The spring (34) is removed in the following way: The nuts (11) and (12) are removed. The lower fork (15), the
toothed rack (35) and the spring (34) will come up also when the nut (12) is removed. If the toothed rack (35) is to
be replaced, this can be done when the lower fork (15) is free. Remove the bolt (38) and the toothed rack can be
replaced.
i) When the counter nut and the pointed screw (36) are removed, the speed selector lever (8) can be removed.
k) Remove the pin bolt (37) by loosening the counter nut.
I) By loosening and removing the 4 bolts (25), the planetary head can be lowered.
7