VIEWSONIC VP3D1 - Manual (Page 11)

6
Using the 3D Video Processor
Once you have connected your devices together with HDMI cables, as shown in the
diagram, you are ready to begin. Power ON your 3D video source, 3D Video
Processor and your 3D projector.(*)
Note *: The 3D video source device must be powered on before the 3D Video
Processor.
PlayStation ® 3 Games
1. Make sure that you have updated your console to the latest software version in
PlayStation
® 3.
2. Go to the "Settings menu → Display settings → Video output → HDMI".
3D Blu-ray
TM
Player
1. Make sure that your player can support 3D Blu-ray TM disc and that 3D output is
enabled.
2. Insert the 3D Blu-ray TM disc into the player, press "Play".
3D TV (e.g. SKY 3D)
1. Contact your TV service provider to enable any 3D channels on your channel
package.
2. Once enabled, switch to the 3D channel. - You should see two images side-by-
side.
3. Press the "SBS Mode" button on the front of the 3D Video Processor.(*)
Note *: If input video is normal 2D, please press SBS mode to "Off".
3D Device (e.g. 3D DV/DC) with 2D 1080i side by side
signal output
1. Connect your 3D device and switch to out 3D content with 2D side-by-side output
to 3D Video Processor. You should see two images side-by-side.
2. Press the "SBS Mode" button on the front of the 3D Video Processor.
3. When you see "3D" in the top right hand corner of the screen, enable your
projector's 3D mode, turn on your 3D glasses and put them on.
4. If necessary, use your projector's 3D Sync-Invert option to optimize your 3D
experience. The option is located in the "Display" section of the projector OSD
menu.
Note: If input video is normal 2D, please press SBS mode to "Off". If SBS mode is
active, 2D video content will not display correctly.