Rear panel layout, Specifications – VOX Amplification USA AC4TVMINI User Manual
Page 4
4
REAR PANEL LAYOUT
1
3
2
1. EXTERNAL SPEAKER Jack - This is used to connect the AC4TVmini to any 16ohm
cabinet.
Note ! When an external cabinet is connected, the internal speaker is disconnected.
(FYI - the AC4TVmini sounds awesome through a VOX V112TV 4 x 12" Cabinet!)
WARNING ! Always use a non-screened VOX approved speaker lead with
the AC4TVmini Amplifier and extension cabinets.
WARNING ! NEVER operate this amplifier without the loudspeaker load
being connected. Serious damage can occur otherwise.
2 . MAINS INPUT - Connect your electricity here with the supplied, detachable Mains (power)
cord.
3 . MAINS FUSE - (serious bit) The fuse provides an overall safety protection in the event
your amplifier develops and electrical fault.
The correct value of the fuse is located on the rear panel of your amplifier and should only
be replaced with one of the same value.
WARNING ! Please ensure that your amplifier is connected to the correct
mains power voltage—please check the rear panel rating plate.
If in doubt consult dealer.
WARNING ! This amplifier must always be earthed (grounded) to prevent
the risk of electrical shock.
SPECIFICATIONS
Power Output:
4 Watts RMS into 16 ohm
Loudspeaker:
6.5 inches 16 ohm
Dimensions (W x H x D): 260 x 280 x 170 mm / 10.24 x 11.02 x 6.69 inches
Weight:
6.1 Kg / 13.45 lbs.
Included items:
Power cable, Owner’s manual
Specifications and appearance are subject to change without notice for improvement.