Viking TMC 148 - Manual (Page 23)

23
ENGLISH
DEUTSCH
FRAN
Ç
AIS
ITALIANO
NEDERLANDS
SVENSKA
ESPA
Ñ
OL
PORTUGU
Ê
S
• Use / to select “MOTORWAY”, for
example, and enter the code number
for the motorway (“007” for the M7).
• Use << >> to select the input position
(the input field will flash).
A maximum of two motorway numbers can
be displayed at the same time. Use << >>
to select the other numbers.
• Use / to enter the first digit of the
road selected, select the next input po-
sition, etc.
Once you have completed your entry,
•
press TMC for approx. 2 sec.,
“A ROAD” will appear in the display.
Now you can enter 5 A roads by their three-
digit code (as described for MOTORWAY).
If you do not want to enter an A road,
•
press TMC briefly.
You can select and store up to 5 motorways
and 5 A roads and activate them, as nee-
ded.
Notes:
The cursor will not move to the next input
field unless the entry in the last field is a
real road contained in the data of the TMC
DriveCard used.
Deleting the input
You can delete the area selected if you
•
press SC briefly.
All of the areas stored on a station selection
key will be deleted if you
•
press SC for approx. 1 sec.
Activating stored areas or roads
(selection)
You can use each of the 5 station selection
keys to activate up to 5 motorways and 5
A roads to make up a “route”. As an alter-
native, you can activate up to 5 areas.
Important: You must have stored this infor-
mation on the station selection keys pre-
viously.
Activating your selection
• Press TMC for approx. 2 sec. until you
hear a beep.
• Briefly press the station selection key
(1 - 5) with the corresponding selection
(areas/roads).
• Press TMC for approx. 2 sec.
If TMC priority has been activated, you will
receive the traffic information just for the are-
as or roads selected.
The amount of information provided will
increase with the number of road numbers
entered.
As a result, it is advisable to enter only as
many road numbers as necessary (max. 5
motorways and 5 A roads).
Following the input of all of the road num-
bers desired, you can activate the input or
store it on a station selection key.
Activating the input
If you would like to activate the information
entered without storing it on one of the sta-
tion selection keys,
•
press TMC for approx. 2 sec.
Storing the input
If you would like to store the information
entered on one of the station selection keys,
•
press the corresponding station selec-
tion key 1 - 5 for approx. 1 sec. (beep).
Overwriting (altering) the input
It is possible to overwrite (alter) the existing
information entered. The new entry must be
stored to delete the old entry.
TMC – Traffic Message Channel