Vector 90510392 - Manual (Page 6)

Controls and Functions
CHARGING THE BATTERY
The unit is delivered in a partially charged state. It must
be fully charged prior to first use by using the 120 volt
AC method.
After charging, disconnect the Adapter from the
external power source, then disconnect the Adapter
from the AC Recharge Port.
CAUTION: Before charging/recharging the unit’s
battery, make sure the power switch is in the OFF position.
120 Volt AC Charging/Recharging
Plug the supplied 120 Volt AC Adapter’s plug into a standard North American
outlet. Connect the adapter’s DC pin into the AC Recharge Port located on the side
of the unit, next to the Battery Status Indicator. The Charging LED will light to indicate
that the unit is charging. The Full Charge LED indicator will light green when the unit
is fully charged.
12 Volt DC Charging/Recharging
The DC recharging method will NOT recharge the unit as effectively as the 120 volt
AC method. The 12 volt DC recharging procedure is recommended only when it is
necessary, since frequent use of the 12 volt DC recharging procedure may shorten
the battery system’s life.
1. Insert the end plug of the12 Volt DC Adapter plug into the vehicle’s 12 volt DC
accessory outlet.
2. Insert the DC pin in the charging port on the side of the light.
3. Charging time using this method is approximately 5 to 6 hours.
4. When charging is complete, remove the power cord.
Note: When using a vehicle’s 12 volt DC accessory outlet as a charging source,
be aware that some vehicles require the ignition be turned on to power the accessory
outlet.
ADJUSTABLE
CARRY STRAP
POWER SWITCH
TOUGH, DURABLE
HOUSING
35 WATT 6000 K
METAL HALIDE
BULB
AC CHARGING PORT
ADJUSTABLE
WORK STAND
CHARGING AND
FULL CHARGE
INDICATOR
BATTERY STATUS
INDICATOR
PUSHBUTTON
CONVENIENT
CARRY HANDLE
5
120 VOLT AC
AND 12 VOLT DC
CHARGING
ADAPTERS
SLH100P_ManualEN_091406 9/28/06 10:55 AM Page 5