Vizio VW37L - Manual (Page 22)

VIZIO VW37L HDTV10A User Manual
2.7
Connecting a PC Computer
1. Turn off the power to the HDTV
and PC Computer.
2. Connect a 15-pin D-Sub RGB
(VGA) cable to the RGB output
of your pc computer and the
other end to the RGB PC input
(blue area) at the rear of the
HDTV.
3. Connect the Audio Out on your
pc computer to the RGB PC
Audio input (blue area) at the
rear of the HDTV.
4. Turn on the HDTV and PC Computer.
5. Select RGB using the INPUT button on the remote or side of the HDTV, or directly by
pressing the RGB button on the Remote Control.
Note:
a) For the best picture quality when connecting a pc computer through RGB
PC, set your pc computer timing mode to VESA 1366x768 at 60Hz. Please
refer to the pc or graphic card’s user guide for additional information on how
to set the timing mode and the video output requirements of the product.
b) A RGB (VGA) cable and stereo mini jack cable are not included and can be
purchased at an electronics store.
2.7.1
Preset PC Resolutions
If connecting to a PC through the RGB PC input, set the TV timing mode to VESA 1366x768 at 60Hz
for best picture quality (refer to the graphic card’s user guide for questions on how to set this timing
mode). Please see the table below for the factory preset resolutions.
Resolution Refresh (Hz) H.Freq (kHz) V.Freq (Hz) H.Sync V.Sync Pixel Freq (MHz)
640x480 60 31.5 59.94 N N 25.175
640x480 75 37.5 75.00 N N 31.500
720x400 70 31.46 70.08 N P 28.320
800x600 60 37.9 60.317 P P 40.000
800x600 75 46.9 75 P P 49.500
800x600 85 53.7 85.06 P P 56.250
1024x768 60 48.4 60.01 N N 65.000
1024x768 75 60.0 75.03 P P 78.750
*1366x768 60 47.7 60.00 P N 85.500
NOTES: N = Negative, P = Positive, * = Primary (Native) Mode
Version 4/17/2007 22
www.VIZIO.com