Vizio NX-100 - Manual (Page 5)

5
Step 3. Press the Start button.
Connection to the pressed Selection button's programmed NX-100 units begins.
If all NX-100 units are connected, the indication "Connection succeed to all designated units.*" is
displayed in the message display area, and the corresponding Selection button changes color to
orange.
* When only a portion of the programmed units is connected, the indication "Connection failure to
some designed units." is displayed.
NX-100 units that are not connected are displayed in the message display area. Depending on the
displayed messages, perform operation again after temporarily terminating the program and waiting a
short time, or after correcting any setting- or unit-related problems. The Selection buttons change to
orange if a connection is made to at least one of the NX-100 units programmed for that button.
Step 4. Broadcasting can begin when the "Connection succeed to all designated units." indication is
displayed.
Step 5. Press the End button after the broadcast is completed.
Step 6. Select [File] → [Exit] to quit the NX-100 Operation program.