Vector VEC248 - Manual (Page 3)

FIGURE 3 - Accessories
Optional wall mounting instructions for battery pack charging unit. FOR INDOOR USE ONLY:
1. Always make sure the area you choose to mount the Battery Pack Charging unit is free
from hidden electrical wires, water pipes and/or gas lines.
2. Select a place close to an indoor 120V ~ 60Hz wall outlet.
3. Do not locate in direct sunlight or close to any heat source.
4. Select a drill for the material and size of mounting screws.
Be careful that no wires, water or gas pipes are behind the wall where the Battery
Charging unit is to be installed.
5. Mark the wall where you want to mount the Battery Pack Charging unit.
6. After carefully drilling starter holes, install the screws so that the Battery Pack Charger
unit can hook onto the screw heads.
NOTE: This Battery Pack Charging unit is designed for INDOOR MOUNTING ONLY!
POWERING THE BATTERY PACK RECHARGE UNIT
Connect the AC/DC Adapter into a working 120 VAC outlet.
Plug the barrel connector into the receptacle on the Battery Pack Recharge unit. The unit may
be either continuously powered or disconnected after use.
If desired, the tools may be placed in the tool wells for storage.
3
CREVICE TOOL
UPHOLSTERY BRUSH
3 FT LONG
VACUUM HOSE
AC/DC ADAPTER
BARREL
CONNECTOR
BATTERY PACK
BATTERY PACK
RECHARGE AND
TOOL STORAGE UNIT