Verilux VF01 - Manual (Page 6)

6
ASSEMBLY INSTRUCTIONS
Read Instructions Carefully Before Assembly:
1. Remove lamp from box and packaging. Remove
red plastic protective pieces from lamp shaft.
NOTE: Please save original packaging for
repacking should you need to return the
product.
2. Set lamp base on the fl oor and insert
the lamp shaft over the base support
part until the screw holes line up as
shown in Fig.1. Insert the screw using
the tightening tool and turn clockwise to
tighten. We recommend assembling the
base fi rst before lamp head.
3. Attach the lamp head gooseneck to the
shaft, tucking the wire into the shaft, until
the screw holes line up as shown in Fig.1.
Insert the screw using the tightening tool
and turn clockwise to tighten. Should you
have diffi culty lining up the base or head
screw holes, refer to the troubleshooting
section of this manual.
Close-up of screw hole
in the lamp base