Venturer PLV76176 - Manual (Page 12)

E - 11
INSTALLATION
INSTALLING / REMOVING ThE BASE STAND
WARNING: The LCD Display is very fragile, and must be protected at all times when removing the base
stand. Be sure that no hard or sharp object, or anything that could scratch or damage the LCD display,
comes into contact with it. Do NOT exert pressure on the front of the unit at any time because the screen
could crack.
1. Disconnect all cables or cords connected to the unit.
2. Lay the unit down on a flat surface with the back side facing
up. Please make sure to place a soft cushioned material (such
as a pillow or thick piece of foam) beneath the screen.
3. To install the base stand, place the base stand on the
mounting slot, push the stand till it locks.
4. To remove the base stand, keep pressing the locking area
of the base stand and pull downwards to release the base
stand.
MOUNTING ON ThE WALL
This unit is VESA-compliant, and is designed to be wall-mounted with a VESA-compliant 3” x 3” (75mm
x 75mm) mounting kit designed for flat-panel TVs (sold separately). Mount this unit according to the
instructions included in the mounting kit.
NOTE
Remove the base stand before mounting the unit on the wall.
PLV76176S7_IB_UL_090723.indd 11 7/24/2009 11:52:49