VocoPro DVX-580G - Manual (Page 12)

12
Connecting to a TV with a VCR
You can also use a VCR to connect video to a TV with no RCA video input. You will need an RCA cable and a 75-ohm “coaxial” type cable. Using the RCA video
cable, connect one end to the VIDEO OUTPUT jack on the DVX-580G and connect the other end of the cable to the VIDEO INPUT of a VCR. Then, using the 75-ohm
“coaxial” type cable, connect one end to the RF OUTPUT of the VCR, and connect the other end to the 75-ohm TV ANTENNA INPUT jack.
Connecting to a TV with S-Video
Using an S-Video cable, connect one end to the DVX-580G’s S-VIDEO OUTPUT jack and connect the other end to the S-VIDEO IN jack on your television.
Connecting to a TV with Component Video
Using 3 appropriate Component Video cables (usually color coded red, blue and green), connect a set of plugs to the COMPONENT VIDEO OUT jacks (Y Cb Cr) on
the DVX-580G and plug the other set of plugs to your COMPONENT VIDEO IN jacks (Y Cb Cr) on your television.
On some TV’s the component video input jacks may be labeled (Y Pb Pr). You will need to press the MODE button on the remote control to toggle between non-
interlaced (HDTV) and interlaced (STANDARD) video output. You can only use the MODE button when there is no disc inserted in the disc tray.
Getting Started
Connexting to a TV with a VCR
VIDEO OUT VIDEO IN
S-VIDEO OPTICAL
VIDEO
SL SR CENTER L R COAXIAL S-VIDEO OPTICAL
SUB Y Cb Cr VIDEO FR FL
S-VIDEO IN
Connexting to a TV with Component Video
SL SR CENTER L R COAXIAL S-VIDEO OPTICAL
SUB Y Cb Cr VIDEO FR FL
S-VIDEO IN COMPONENT VIDEO