VIVANCO UR 12 - Manual (Page 2)

Vivanco GmbH, Ewige Weide 15, D-22926 Ahrensburg, Fax: +49(0)4102 31444,
E-Mail: [email protected] 2
it has been set and is not designed to replace all the functions of the original remote
controls. In order to be able to control your devices, you must set the remote control
as described in the section "Code entry".
2 Inserting batteries
Open the battery compartment on the underside of the UR, see Fig.. Then insert 1
new CR 2032 lithium battery. Make sure that the polarity is correct: the "+" and "-"
markings on the batteries and in the compartment must match. To check functionality,
press the
PWR button. If everything is correct the red lamp flickers when the button is
pressed.
Lithium Battery:
Caution: Danger of explosion if battery is incorrectly replaced. Replace only with the
same or equivalent type recommended by the manufacturer. Dispose of used
batteries according to the manufacturer’s instructions.
3 Code entry
The correct control codes can be set via direct code entry or automatic code search.
Direct code entry
Using the enclosed code list, note the possible codes for the device and the brand.
To set your TV set, proceed as follows:
1.
Using the enclosed code list, find the codes to control your brand of television
(TV). It is possible that there are several suitable codes and you should find out
the most suitable.
2. Switch on a program on your TV.
3. Press the SET button, hold it down and at the same time press a device button,
e.g. TV*), until the red lamp comes on.
4. Then enter one of selected three-digit codes.
5. When the first and second number buttons are pressed the lamp goes out
briefly; when the third is pressed it stays out.
6. Try out the functions. If everything is okay, you can set the remote control as
described in steps 1 to 5 for other devices. If it is not okay, try another code for
the same brand.
The letters on the device buttons TV1/TV2*), SAT1/SAT2*), DVB1/DVB2*)
DVD1/DVD2*), VCR1/VCR2*), AUX1/AUX2*), AUX1/AUX2*) are for your orientation
only. You can set each type of device under any of the buttons.
If you do not find a suitable code for a device, look for it using the code search.
*): All keys of the device can be assigned twice so that 12 different devices can be
controlled altogether. If you press a key once according to these instructions you can
enter a device code for the first assignment or control the first device. If you press a
device key twice within 2 seconds you can set the key for a second device, or control
a second device via the key.
Code search
To control e.g. a TV:
1.
Switch on a program on your TV (on the TV itself or with the original remote
control).
2. Press the SET button, hold it down and at the same time press a device button,
e.g. TV*), until the red lamp comes on.
3. Then press the SET button again briefly, the lamp starts to blink.