Vox Valvetronix Amp VT15 - Manual (Page 13)

13
Switching to Manual mode
If the MANUAL LED is dark, you’re not in Manual mode. Press the [MANUAL]
switch; the MANUAL LED will light, and you’ll be in Manual mode.
NOTE: In Manual mode, adjusting a parameter whose setting is not determined
by the position of a knob (i.e., the effect parameters and the noise reduction
setting) will save that setting automatically. Those settings will be recalled the
next time you enter Manual mode. However if the [EFFECT] selector is set to
a different position than before, the default settings for that effect type will be
loaded for the effect parameters.
Channel Select mode (recalling user programs)
In Channel Select mode you can use the [BANK] switch and [CHANNEL] switches
to recall the programs that are saved in each channel of the bank; all of the amp and
effect parameters will switch automatically.
Switching to Channel Select mode
If the BANK and CHANNEL LEDs are dark, you’re not in Channel Select mode.
Press the [BANK] switch or a [CHANNEL] switch; the BANK and CHANNEL LEDs
will light, and you’ll be in Channel Select mode.
Switching channels
Press a [CHANNEL] switch to change channels. The program specified for that chan-
nel will be selected, regardless of the position of the top panel selectors and control
knobs. If you press the [BANK] switch, the bank will change, and the channel of the
same number that had been selected in the previous bank will be selected.
HINT: If you connect the optional foot switch (VOX VFX5: sold separately) to
the rear panel, you’ll be able to switch banks/channels using your foot. For
details, refer to “Using the foot switch (VOX VFS5)” (p.17).
HINT: If you want to disable the effects, press the [BYPASS] switch. The BYPASS
LED will light and the effect will be bypassed (except for reverb). If you press
the [BYPASS] switch once again, bypass will be cancelled and the effect will be
enabled. The bypass setting is maintained even if you switch modes or pro-
grams, or turn off the power.