Viper 671XV - Manual (Page 21)

18 © 2 0 0 4 d i r e c t e d e l e c t r o n i c s , i n c .
panic mode
If you are threatened in or near your vehicle, you can attract
attention by triggering the system with your 2-way remote. Just
press for two seconds, and you will enter Panic Mode. The
siren will sound and the parking lights will flash for the
programmed siren duration. To stop Panic Mode at any time,
press on the 2-way remote again.
The remote responds with one flash of the Red LED upon
entering Panic Mode and two flashes of the Red LED upon
exiting Panic Mode.
valet ® mode
You can prevent your security system from automatically arming
and triggering by using Valet
® Mode. This is very useful when
washing the vehicle or having it serviced. In Valet ® Mode, the
security system will not arm, even with the 2-way remote, but all
convenience functions (door locks, trunk release, etc.) will
continue to work normally.
To enter or exit Valet ® Mode:
1. Turn the ignition on.
2. Turn the ignition off.
3. Press and release the Valet ®
button once within 10 seconds.
The in-vehicle status LED will light solidly if you are entering
Valet ® Mode, and it will go out if you are exiting Valet ® Mode.
The remote will respond with 3 Orange LED flashes on entering
and 2 beeps and 3 Orange LED flashes on exiting Valet ® Mode.
DRW-35
➜
➜