Vestax PMC-25 - Manual (Page 5)

4
F U N C T I O N S
PROGRAM SECTION
MONITOR SECTION MIC SECTION
PROGRAM SECTION MASTER SECTION
1 INPUT SELECT (Input Select Switch)
Used to select input to be sent to each PGM channel.
2 TRIM (Trim Control Volume)
Adjusts the Input level of each channel. For proper
adjustment, please set the INPUT FADER to
Maximum position then adjust TRIM so that the
INPUT LEVEL METER shows around 0 dB at
nominal level.
3 PEAK
Turns on when the signal of HI, MID, LOW range
hits the peak.
4 HI (Isolator HI)
Cuts and boosts the high frequency range. The level
is flat when this knob is set at 12 o'clock. High
frequency range is boosted up to +4dB when this
knob is rotated clockwise. When the knob is rotated
counter-clockwise, high frequency range is cut off
up to infinity level. For example, it can be used to
emphasise or cut off the cymbals or high hats.
5 MID (Isolator MID)
Cuts and boosts the mid frequency range. The level
is flat when this knob is set at 12 o'clock. Mid
frequency range is boosted up to +4dB when this
knob is rotated clockwise. When the knob is rotated
counter-clockwise, mid frequency range is cut off up
to infinity level. For example, it can be used to
emphasise or cut off the vocals or guitars.
6 LOW (Isolator LOW)
Cuts and boosts the low frequency range. The level
is flat when this knob is set at 12 o'clock. Low
frequency range is boosted up to +4dB when this
knob is rotated clockwise. When the knob is rotated
counter-clockwise, low frequency range is cut off up
to infinity level. For example, it can be used to
emphasise or cut off the bass.
6 5 4
9
3
1
2
10
8 7