VocoPro KC-300Pro - Manual (Page 8)

8
Before Getting Started:
Things to Consider
It is very important to read the following instructions prior to starting any installation
procedures. Doing so will ensure a correct installation and may save you some time as well.
Protect Against Power Surges
• Connect all external components before you plug any of their power cords into the
wall outlet.
• Turn off the KC-300Pro before you connect or disconnect any cables.
• Make sure all cables are properly grounded.
Protect Components from Overheating
• Don’t block ventilation holes. Arrange any components so that air can circulate freely.
• Don’t stack components.
• If you place the KC-300Pro on a stand, make sure you allow adequate ventilation.
Position Cables Properly to Avoid Audio Interference
• Insert each cable firmly into the designated jack.
• If you place components above the KC-300Pro, route all cables down the side of the
back of the KC-300Pro instead of straight down the middle of the back of the
KC-300Pro.
Important Stand and Base Safety Information
Choose the location for your KC-300Pro carefully. If the KC-300Pro is placed on a stand or
base, ensure that it is of adequate size and strength to prevent it from being accidentally
tipped over, pushed off, or pulled off. This could cause personal injury and/or damage to the
KC-300Pro.
Use Indirect Light
Don’t place the KC-300Pro where sunlight or room lighting will be directed toward the
screen. Use soft or indirect lighting.