Viper 135HF - Manual (Page 14)

11
© 1999 Directed Electronics, Inc.
The engine will shut down and the parking lights will flash four
times. The engine will then restart to confirm that Timer Mode has
been entered.
The engine may be allowed to run for its preset time or can be
shut down by pressing Buttons and again. Either way, it
will restart every three hours for a total of six cycles. If the unit
receives a shutdown input while operating in the timer mode the
engine will stop, but will restart, on schedule, again in three hours!
To exit Timer Mode:
Timer Mode can be exited by turning the ignition on with the key
any time the engine is not running. You can also exit Timer Mode
manually from the transmitter by following these steps:
1. Start the engine by pressing and .
2. Press and release .
3. Within two seconds press and release and again.
4. The engine will shut down and the parking lights will flash
four times to confirm that Timer Mode has been exited. If the
car has already been remote started, skip Step One.
The Valet ® Take-Over feature allows the vehicle to remain running
after the key has been removed from the ignition. This feature is
useful for occasions when you wish to exit and lock the vehicle for
short periods of time, but would like to leave the motor running
and the climate controls on.
Valet ® Take-Over