Viking F20533 EN - Manual (Page 12)

23 22
1
Measur
ement
(A)
Mea
sure
men
t (A
)
Measur
ement
(A)
2
Measur
ement (A)
Me
asu
rem
ent
(A
)
+1/2” +1
/2”
(1.3 cm) (1.3
cm
)
Measur
ement (A)
+1/2”
(1.3 cm)
X X
YY
Measure from floor to bottom
of the anti-tip opening located on the back of range.
This will be measurement (A).
1
Note: Refer to electrical and gas
requirements section for proper
installation information.
3
Mark and drill holes where bracket will be located.
4
Attach bracket with
mounting hardware provided.
Connect gas and electrical. Before placing appliance in operation,
always check for gas leaks. This must be performed by your
dealer, a qualified licensed plumber, or gas service company.
Leveling/Adjustments/Alignments
(cont.)
Connecting Gas & Electric
WARNING
Tipping hazard.
To reduce the risk of property
damage or personal injury;
install anti-tipping device
provided in accordance with
the installation instructions
in this document. Device
must be engaged properly to
prevent product from tipping
over.
7
Set the high corner of range so that the top of side trim is
3/8” (0.95 cm) above countertop. Level range to high corner.
DANGER
Gas leak hazard.
To avoid risk of personal injury
or death; leak testing of the
appliance must be conducted
according to the manufacturer’s
instructions. Before placing appliance in
operation, always check for gas leaks
with soapy water solution.
• DO NOT USE AN OPEN FLAME TO
CHECK FOR GAS LEAKS.
Anti-tip Device Installation
Anti-tip Device Installation
(cont.)
Anti-tip location for each range width.
Range
Width
“X”
Dimension
“Y”
Dimension
30” 3-5/8” (9.2 cm) N/A
36” 8” (20.3 cm) N/A
48” 5” (12.7 cm) N/A
60” 5” (12.7 cm) 24-7/8” (63.2 cm)
Locate anti-tip bracket on rear wall with the top left
corner at measurement (A) plus 1/2” (1.3 cm) from the
floor and “X” dimension (see chart) from where the
right side of range (facing range) is to be located and
“Y” dimension (see chart) from where the left side of
the range (facing range) is to be located.