Verilux VH02 - Manual (Page 6)

5
OPERATION
• Gently step on the power switch once to
activate the Sweeper and the UV-C light
function.
• Press switch second time to switch off.
ATTENTION: This Unit features a safety cut-
off switch for the UV-C light. When the wheels
come off the fl oor, the light automatically
switches off. Do not allow the UV-C Light to
come into direct contact with the eyes or skin.
CHARGING INSTRUCTIONS
• Connect battery charger to the Sweeper
unit. Plug the charger into the electric outlet
located on your household wall to start
charging.
• Sweeper may be charged after each use
for not more than 24 hours or damage to
batteries might occur.
• You can notice the power condition
according to the LED indicator light located on the charger.
• When charging the Sweeper, sweeping and sterilizing functions are
inoperable.
REPLACING THE BATTERY
• Turn off the power.
• Turn the Sweeper upside down and open
the battery cover according to the illustration
shown.
• Pull out the battery pack and disconnect it from
the power wire.
• Insert a new battery pack and reconnect the
power wire.
• Replace the battery cover and recharge the
sweeper to get it ready to operate.
ATTENTION: New batteries require an initial
12 hour charge before using. After that, recharge until green light appears.
Never charge for more than 24 hours or damage to the batteries may occur.
2 Step Switch
1st Step
2nd Step
SWEEP / STERILIZE /
LIGHT UP
TURN OFF
Recharge Status
RED LIGHT
Initial
Charging Phase
Final
Charging Phase
Fully charged–
remove charger
ORANGE LIGHT
GREEN LIGHT