Verilux PLANETLIGHT PL04 - Manual (Page 10)

10
HEADER Troubleshooting
Before requesting service on your Verilux ® lamp, please read the
following:
• Make sure all power connectors, cords and plugs are inserted fully
and securely.
• Be sure the bulb is securely seated into the socket (see page 9).
• Make sure there is power to the wall outlet or try another outlet.
• CAUTION: DISCONNECT LAMP BEFORE PERFORMING
ALIGNMENT ACTIVITY. MISE EN GARDE : DÉBRANCHER LA
LAMPE AVANT D’EFFECTUER SON ALIGNEMENT. Correct alignment
with screw holes can be accomplished by following these steps:
1. Always start with the base and work your way up the shaft,
attaching the head last.
2. Place your foot on the base of the lamp on the floor.
3. While holding the shaft with your hand, gently rock the unit back
and forth.
4. Shaft should ease into the socket and the screw holes will align.
Be sure the bulb is securely seated into the socket, repeat the bulb
installation process. CAUTION: DISCONNECT LAMP FROM OUTLET
PRIOR TO REPEATING THE BULB INSTALLATION PROCESS. MISE EN
GARDE : DÉBRANCHER LA LAMPE DE LA PRISE DE COURANT AVANT
DE POSER UNE NOUVELLE AMPOULE.