Vizio IR-200BC - Manual (Page 6)

Step 4. Turn off the power of the infrared wireless microphone to be charged, then insert the 2 IR-200BT
rechargeable batteries into the microphone. For proper battery insertion, refer to the instruction
manual enclosed with the infrared wireless microphone.
Note
Charging cannot be correctly performed if the infrared wireless microphone's power switch is set to
the ON position.
Step 5. Insert the infrared wireless microphone fully into
the charger's microphone receptacle and confirm
that the charging indicator (red) is lit.
[For the IR-200M microphone]
• Leave the mounting adapter attached.
• Insert the microphone into the hole in the
adapter to charge.
[For the IR-300M microphone]
Remove the mounting adapter to charge.
(Refer to the figure at right.)
Charging takes approximately 3 hours, after which
the full-charge indicator lights green.
Step 6. Turn off the charger's power once charging is complete.
Notes
• Be sure to turn off the charger's power after charging is complete in order to save standby power.
• The infrared wireless microphone becomes warm after charging completion, however this is not a
failure.
• Hold the charger when detaching the infrared wireless microphone from the charger.
6
Mounting adapter
Pull up the adapter holding down this part
(another on the opposite side).
Charger
Removing the mounting adapter