Viking InterWorks MAC OS - Manual (Page 7)

VIKING COMPONENTS 56K USB MODEM USER’S GUIDE
Hardware Installation (Continued)
2. Return the modem right side up and feed the phone cables through the back
of the base.
3. Power on your computer.
4. Locate an available USB port on your computer and connect it with the USB
cable on the back of the modem. This port is usually located on the back of your
system. If you are not familiar with the location of the USB ports on your com-
puter, please refer to your system’s “Owner’s Guide” for detailed instructions.
Note: The Viking Components USB modem must be connected to a USB port on
your computer or to a powered USB hub.
Your hardware setup in now complete. To complete the setup of your modem,
please proceed to the chapter 4 “Software Installation” in this guide.
Chapter 3 5