VTech Computer Pal In Concert - Manual (Page 5)

BATTERY INSTALLATION
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the back of the unit
and open it.
3. Insert 4 “AA” batteries (UM-3/LR6) as illustrated.
(The use of new, alkaline batteries is
recommended for maximum performance.)
4. Replace the battery cover.
BATTERY NOTICE
•
Install batteries correctly observing the polarity (+,–) signs to avoid leakage.
• Do not use rechargeable batteries.
• Do not mix old and new batteries.
• Do not use batteries of different types.
• Remove exhausted or new batteries from equipment when you are not going to
use the unit for a long time.
• Do not dispose of batteries in fire.
• Do not attempt to recharge ordinary batteries.
• The supply terminals are not to be short-circuited.
NOTE: If for some reason the program/activity stops working, please follow these steps:
1. Please turn the unit OFF.
2. Interrupt the power supply by removing the batteries.
3. Let the unit stand for a few minutes, then replace the batteries.
4. Turn the unit ON. The unit will now be ready to play again.
If the problem persists, please call our Consumer Services Department at 1-800-521-
2010 in the U.S. or 1-800-267-7377 in Canada.
AC ADAPTOR CONNECTION
Use a standard 9V 300mA AC center-positive adaptor.
1. Make sure the unit is OFF.
2. Locate the adaptor jack on the back of the unit.
3. Insert the adaptor plug into the unit’s adaptor jack.
4. Plug the adaptor into a wall outlet.
5. Turn the unit ON.
NOTE: If for some reason the program/activity stops working, it may be the result
of the adaptor connection. Please follow these steps:
1. Please turn the unit OFF and unplug the adaptor for 15 seconds.
2. Reinsert the adaptor plug into the adaptor jack.
3. Turn the unit ON.
2
338im 10/12/98, 11:34 4