VeriFone 250 - Manual (Page 6)

Using the Verifone 250 Receipt Printer with MPI 2002
Page 6 of 6
Finally, toggle the Power Switch to determine if the installation was successful.
The printer will make some noises and the Power Light will turn green or red.
Installing Paper Roll
Turn the power on before installing the Paper Roll. Remove the Roll Cover from
the Printer Unit, if attached. Put the Spindle through the Paper Roll. Refer to the
diagram below for the proper orientation of the paper roll before proceeding.
Insert the Paper Roll and Spindle into the slots on each side of the paper bin.
Push the end of the Paper Roll into the paper feed slot and press the Paper Feed
Button until the paper begins to be pulled through the Printer Unit. Tighten the
Paper Roll or use the Paper Feed Button to remove any slack in the Paper Roll,
and then replace the Roll Cover on the Printer Unit.
Installing Serial Cable
Using the special PC to Receipt Printer serial cable (Part number 10765-00) we
can now connect your printer to your computer. ENSURE THAT THE PRINTER
AND YOUR COMPUTER ARE OFF BEFORE PROCEEDING. NEVER INSTALL
ANY SERIAL DEVICE TO YOUR COMPUTER IF THE DEVICE OR YOUR
COMPUTER ARE POWERED-UP. THIS CAN CAUSE SERIOUS DAMAGE TO
THE DEVICE OR YOUR COMPUTER!