Verilux NATURAL SPECTRUM VF02 - Manual (Page 8)

8
Assembly Instructions — continued
3. Attach the lamp head gooseneck to the
shaft until the screw holes line up as
shown in Fig. 3. Use care when tucking
the wire into the shaft. Form a loop with
any excess wire prior to tucking it. Insert
the screw using the tightening tool and
turn clockwise to tighten.
4. Remove the light diffuser from
the protective plastic bag.
Insert the plastic pegs at the
bottom of the light diffuser into
the openings near the bulb
socket. Snap the tab
into place as shown
in Fig. 4.
Note: Be sure all
styrofoam packing
is removed from the bulb
area prior to installing the
light diffuser.
Close-up of screw hole in
the lamp head
Fig. 3
Fig. 4