Viking F20686 - Manual (Page 18)

35
Pan Placement Tips
• When using large (15" x 13") flat pans or trays that cover most of
the rack, rack positions 2 or 3 produce the best results.
• When baking on more than one rack, it is recommended to use one
of the convection modes and the 2nd and 4th position or the 3rd
and 5th position for more even baking. When baking on three racks,
use any combination of positions 2, 3, 4, and 5 for more consistent
results.
• Stagger pans in opposite directions when two racks and several pans
are used in conventional bake. If possible, no pan should be directly
above another.
• Allow 1 to 2 inches of air space around all sides of each pan for even
air circulation.
Using the Oven
O
p
e
ra
tio
n
34
Condensation
The oven is supplied with a system which provides a natural circulation
of air. In most cases, this natural circulation will eliminate any observed
condensation. However, there will be instances where condensation is
observed. This is NOT a sign that the oven is not working properly.
Condensation can occur depending on the following factors:
• Type of food being cooked
o Steam and condensation is a natural by product of cooking any
food with high water content, such as frozen food, chicken, etc.
o Use a covered container, where practical, when cooking to
reduce the amount of condensation that forms.
• Length of cooking time
o If the oven is going to be used for prolonged periods of time,
then additional ventilation may be required.
o Do not leave food in the oven to cool after it has been cooked
and the oven has been switched off.
o To reduce condensation, ensure the oven is well heated before
placing food in the oven cavity.
• Blockage of the oven’s air flow
o If the oven air flow is changed, the oven will not perform to
specification.
• Proper installation ventilation
o The oven needs good ventilation within the installed cabinets
to perform per specification.
• Type of cabinetry the oven is installed in
o Cabinets need to meet specific temperature requirements.
o Some cabinetry materials have high water contents that can
outgas during the heating cycle.
• Ambient conditions in the kitchen including humidity and
temperature
Using the Oven
O
p
e
ra
ti
o
n
Single Rack Pan
Placement
Multiple Rack Pan
Placement