ViewEra V191 - Manual (Page 6)

5
2. Installation
The monitor is equipped with an automatic sensing AC power adapter for a voltage range from 100 to
240 VAC at a frequency of 50 to 60 Hz. Before connecting the cables, please make sure that the monitor
and the computer power are both turned off. Please follow the steps to install your monitor.
2.1 Connecting the signal cable
Plug one end of the VGA cable or video cable to a computer or video device and the other end to the
video signal connector on the monitor, and then tighten the two screws on the cable connector on both
ends.
2.2 Connecting the power adapter and power cord
First, connect the AC power adapter to the DC jack on the monitor. Second, connect one end of the
power cord to the power adapter and the other end to the electrical outlet
2.3 Connecting the audio cable
Plug one end of the audio cable to audio jack on the computer or a video device and the other end to the
audio jack on the monitor.
2.4 Installing the monitor base
Place the monitor base on the monitor stand and align the screw on the monitor base against the screw
hole on the monitor stand. Then tighten the screw until the monitor base is securely attached to the
monitor stand.