VIEWSONIC vmp52 vs12840 - Manual (Page 10)

5 ViewSonic VMP52
Instruction to install the built-in SATA(2.5’) HDD
1. Remove four hex screws from the rear (connector panel) us-
ng the suppled tool.
2. Slide out the rear cover, complete with circuit board. It may be
necessary to push gently from the front by removng the front
cover va four hex screws.
3. Place the SATA(2.5’) HDD closely at the back of circuit board,
then insert it into the SATA matching slot.
4. Tighten the screws on the SATA (2.5) HDD with the supplied
tool.
5. Slide the circuit board along with the board slot into the main
case, then tghten the screws on the man case.
Note:
1) Please format the SATA (2.5’) HDD before fitting it into
the player.
2) Make sure not to damage embedded components on the
crcut board.
3) After successful nstallaton, enter setup menu, and
choose “SATA” in device selection, for detailed instruction
please refer to Page 11.