Vector Compact Pro VEC020C - Manual (Page 2)

2
SAFETY INFORMATION
WARNINGS:
Warning statements identify conditions or practices that may result in personal injury or loss of life.
1) When working with lead acid batteries, always make sure immediate assistance is available in case of
accident or emergency.
2) Always use protective eyewear when using this product: contact with battery acid may cause blindness
and/or severe burns, be aware of first aid procedures in case of accidental contact with battery acid.
3) There is a risk of explosive gases being released when lead acid batteries are being charged or discharged.
Failure to follow instructions may cause property damage, explosive hazard, and/or personal injury
4) Make sure the Safety Switch is Off before connecting battery clamps to discharged battery. This will
enable the polarity alarm to function.
5) When connecting the battery clamps to a discharged battery, and an alarm sounds, do NOT turn on the
Safety Switch - the polarity is reversed. Interchange battery clamps before turning the Safety Switch ON.
6) When charging unit from a 110/120-volt ac electrical outlet in any wet or damp area, make sure that
the outlet used is protected by a ground fault interrupt (GFI) Switch.
7) When charging the unit near water, do not allow the electrical cords and outlets to get wet or come near
water-electrical shock could result.
8) Jumpstart procedures should only be performed in a safe, dry, well-ventilated area.
9) Always store battery clamps in built-in holsters when not in use. Never touch battery clamps together-
this can cause dangerous sparks, power arcing, and/or explosion.
10) When using this unit in proximity to the vehicle’s battery and engine, stand the unit on a flat, stable surface,
and be sure to keep all clamps, cords, clothing and body parts away from moving vehicle components.
11) Do not wear vinyl clothing when jumpstarting a vehicle-friction can cause dangerous static electricity
sparks. Remove all jewelry or metal objects that could cause short circuits or react with battery acid.
12) Always disconnect the negative (Black) jumper cable first: followed by the positive (Red) jumper cable.
13) Never allow red and black clamps to touch each other or another common metal conductor-this could
cause damage to the unit and/or create sparking/explosion hazard. Always store battery clamps in
built-in holsters when not in use.
14) Do not expose battery to fire or intense heat as it may explode. Before disposing of the battery, protect
exposed terminals with heavy-duty electrical tape to prevent shorting (shorting can result in injury or fire).
15) Do not smoke or use inflammable items (matches, cigarette lighters, etc.) while working on a vehicle’s
battery system.
16) Keep unit out of reach of children (whether stored, or in use)!
FIRST AID:
• SKIN: If battery acid comes in contact with skin, rinse immediately with water, then wash thoroughly
with soap and water. If redness, pain, or irritation occurs, seek immediate medical attention.
• EYES: If battery acid comes in contact with eyes, flush eyes immediately-for minimum of 15 minutes-
seek immediate medical attention.
CAUTIONS:
Caution statements advise against certain conditions and practices that may result in damage to
vehicles, appliances and/or The START-IT Compact Pro Jumpstart System.
IMPORTANT:
Although this unit is delivered in a partially-charged state - you must fully charge it with the supplied
110/120 Volt AC charger for a full 24 hours before using it for the first time. You can not overcharge
the unit using the AC charger method.
1) Use only the supplied cords/adapters for recharging this unit. Do not recharge for more than 3-4 hours
maximum using 12 Volt DC method. Recharge unit after each use.
2) All On/Off switches should be in the OFF position when the unit is charging or not in use. Make sure all
switches are in the OFF position before connection to a power source or load.
3) Never insert anything other than the supplied power/recharging cords or recommended appliance power/
recharging cords into the 12 Volt DC charging/power socket on this unit. Do not use any accessory that is
not recommended or provided by the manufacturer.
4) Do not use this unit to operate appliances that draw more than 20 amps.
5) This system is designed to be used only on vehicles with 12 Volt DC battery systems. Do not connect to a
6 Volt or 24 Volt battery system.
6) This system is not designed to be used as a replacement for a vehicular battery. Do not attempt to operate a
vehicle that does not have a battery installed.
7) Vehicles that have on-board computerized systems may be damaged if vehicle battery is jumpstarted.
Before jump-starting, read the vehicle’s owner’s manual to confirm that external-starting assistance is advised.
8) Excessive engine cranking can damage a vehicle’s starter motor. If the engine fails to start after the recommended
number of attempts. Discontinue jumpstart procedures and look for other problems that may need to be corrected.
9) Although this unit contains a non-spillable battery, it is recommended that unit be kept upright during
storage, use and recharging. To avoid possible damage that may shorten the unit’s working life, protect
it from direct sunlight, direct heat and/or moisture.
10) Check unit periodically for wear and tear. Replace worn or defective parts immediately contact Vector
customer service department at (954) 584-4446.
11) Do not attempt to jump-start a frozen battery.
12) Never submerge this unit in water.
13) DO NOT over-inflate tires.