Vivid Audio Digital Camera 25 - Manual (Page 23)

22
Your camera uses SDRAM memory, which requires a constant electric current to store your photos.
Should your camera lose power (for instance if the battery dies or run out of power) all stored pictures will be lost. We
recommend always downloading your photos to your computer as soon as possible to prevent unintentional data loss.
Q: How do I get to take 120 photos?
Refer to pages 13 -14, by changing the settings of Photo Resolution to VGA and Photo Quality to
Normal Quality you will be able to take up to 120 photos when starts with empty memory.
The photo quantity that can be taken before the memory gets full depends on the settings of
Photo Resolution and Photo Quality. Photo taken with lower resolution or lower quality takes less
memory size and therefore more photos can be taken
This device complies with the part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Caution: changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with instructions may cause harmful interference to radio or -television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
__ Reorient or relocate the receiving antenna.
__ Increase the separation between the equipment and receiver.
__ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
__ Consult the dealer or experienced radio/ TV technician for help.