4 connections to the plasmaview and vhd controller, Connecting the plasmaview to the vhd controller, Connections to the plasmaview and vhd controller – Vidikron VP-6500VHD User Manual
Page 29: 3. connecting the plasmaview to the vhd controller, Pre l iminar y, Risk of electric shock do not open
Vidikron PlasmaView Owner’s Operating Manual
19
PRE
L
IMINAR
Y
3.4
Connections to the
PlasmaView and VHD
Controller
Proceed as follows to connect the PlasmaView to the VHD Controller, your video sources,
external controller(s) – if present – and AC power.
When connecting your equipment:
• Turn off all equipment before making any connections.
• Use the correct signal cables for each source.
• Ensure that the cables are securely connected. Tighten the thumbscrews on connectors
that have them.
Connecting the PlasmaView
to the VHD Controller
Connect the VHD Controller to the PlasmaView as shown in Figure 3-3 and described in the
sections that follow.
Figure 3-3. Connecting the PlasmaView to the VHD Controller
Pb
Pr
Y
Video
3
IR
RS-232 Control
S-Video 1
S-Video 2
HD1
HD2
1
2
R/Pr
G/Y
B/Pb
R/Pr
G/Y
B/Pb
H
V
HDMI 1
HDMI 2
HDMI Out
H
V
TRIGGERS
RS-232 Out
CAUTION:
TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER. NO USER-
SERVICEABLE PARTS INSIDE. REFER SERVICING
TO QUALIFIED SERVICE CENTER.
AVIS: RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
!
WARNING: TO REDUCE THE RISK OF FIRE
OR ELECTRIC SHOCK, DO NOT EXPOSE
THIS APPLIANCE TO RAIN OR MOISTURE.
100-230VAC 50-60 Hz, 165 Watts Max
INPUTS
SYSTEM CONTROL INTERFACE
Component Video
SDI
Option
Serial No
Video Processor / Controller
Model
Made In USA
SERIAL
PC IN
AUDIO
SLOT1
SLOT3
P
R
/C
R
/R
P
B
/C
B
/B
Y/G
AUDIO
R
L
COMPONENT/RGB IN
SLOT2
AUDIO
DVI-D IN
Optional Terminal
Board Insert Slot
(covered)
HDMI OUT
RS-232
OUT