Vent-a-Hood 812-3450-0 (Hickory) - Manual (Page 5)

4
Choose a good, cleared assembly area and get a
friend to help you put your grill together. Lay
cardboard down to protect grill finish and
assembly area.
Step 1
Stand body of grill on one end. Insert shelf
brackets into legs without axle holes (Grill King
only). Align the bolt holes in the longer set of
legs to bolt holes in the body. Insert two 6 x
50mm screws through each leg and secure with
nut (hand tighten only at this point).
Step 2
With the help of a friend, turn the body to the
opposite side. Align the bolt holes in the short
legs to bolt holes in the body. Insert two 6 x
50mm screws through each leg and secure with
nut (hand tighten only at this point).
Step 3
Insert wire wood rack (curved ends pointed
down) into holes on bracket near bottom of legs
then tighten all bolts and nuts until secure.
Step 4
Insert axle through axle holes in short legs.
Place wheels on axles with recessed hubs
facing out. Insert wheel cap through center of
wheel to secure the wheel to the axle. Push
until secure.
Air
Vent
curved end
pointed down
Rear (Short) Leg
(Grill King Deluxe)
Front (Long) Leg
(Grill King Deluxe)
Rear (Short) Leg
(Grill King)
Front Leg
(Grill King)
Shelf Bracket
(Grill King)
Push Cap