Venturer CD7106VI - Manual (Page 8)

- 7 -
LISTENING TO THE RADIO
Presetting Stations
The unit can store a total of 20 stations in memory (10FM, 10AM). Presetting allows you to tune in to
a station directly.
1. Tune in to a desired station.
2. Press the PROG/MEM/
button. The preset number will blink and the “MEM” indicator will be shown
on the display.
3. Press the MEM.UP/ button to select the preset number.
4. Press the PROG/MEM/ button again to store it in memory.
5. Repeat steps 1-4 to store other stations.
Tuning in to a Preset Station
Press the BAND/ STOP button to select AM or FM then press the MEM.UP/ button to select a preset
number.
Searching for a Station Automatically
• Press and hold the or button until the tuner starts searching for a station, then release. After
tuning in a station, the search stops.
• The search may not stop at a station with a very weak signal.
1. Press the STANDBY/ON button to turn the unit on.
2. Press the FUNCTION button to radio mode.
3. Press the BAND/ STOP button to select a band (AM/FM).
4. Press the
or button to tune in to a station.
• Adjust the volume levels.
For Better Reception
FM: Fully unwind the antenna wire. Extend the antenna wire and place it in the position that sounds best.
Note: Do not connect the FM antenna to an outside antenna.
AM: Reposition the unit to get better AM reception.
Notes:
• When the reception is good, the “
STEREO ” indicator will appear on the display.
• To prevent interference to the AM signal, please keep the AC adapter 3.17 feet (1 meter) away from the
main unit.
1. Press the STANDBY/ON button to turn on the unit.
2. Slide the OPEN knob to open the CD door. Place a disc in the center with the label side front and then
close the CD door gently.
3. Press the FUNCTION button to CD mode. “ ” appears and “- -” blinks on the display. Then the total
track no. is shown on the display.
4. Press the PLAY/PAUSE button to start playing.
• Adjust the volume levels.
To Pause Playback
• Press the PLAY/PAUSE button.
• To resume playback, press the PLAY/PAUSE button again.
To Stop Playback
• Press the BAND/ STOP button.
CD PLAYBACK