Vector Start-It AB121903 - Manual (Page 4)

CAUTIONS
CAUTION STATEMENTS ADVISE AGAINST CERTAIN CONDITIONS AND
PRACTICES THAT MAY RESULT IN DAMAGE TO VEHICLES, APPLIANCES
AND/OR THE START-IT JUMPSTART SYSTEM.
• Important: although this unit is delivered in a partially-charged state - you must
fully charge it with the supplied 120 volt AC charger for a full 24 hours, before
using it for the first time.
• Important: do not overcharge unit, this will reduce battery life.
• Use only the supplied cords for recharging/operating this unit. do not recharge
for more than 3-4 hours maximum using 12 volt DC method. recharge unit after
each use.
• All on/off switches should be in the off position when the unit is charging or not
in use. make sure all switches are in the off position before connection to a power
source or load.
• Never insert anything other than the supplied power/recharging cords or
recommended appliance power/recharging cords into the 12 volt DC
charging/power socket on this unit. do not use any accessory that is not recom-
mended or provided by the manufacturer.
• Do not use this unit to operate appliances that draw more than 20 amps.
• This system is designed to be used only on vessels or vehicles with 12 volt dc bat-
tery systems. do not connect to a 6 volt or 24 volt battery system.
• This system is not designed to be used as a replacement for a vehicular battery.
Do not attempt to jumpstart a vessel or vehicle that does not have a battery
installed.
• Excessive engine cranking can damage a vessel’s or vehicle’s starter motor.
if the engine fails to start after the recommended number of attempts. discontinue
jumpstart procedure and look for other problems that may need to be corrected.
• Although this unit contains a non-spillable battery, it is recommended that unit be
kept upright during storage, use and recharging. to avoid possible damage that
may shorten the unit’s working life, protect it from direct sunlight, direct heat
and/or moisture.
• Check unit periodically for wear and tear. replace worn or defective parts imme-
diately. Contact Vector® customer service department at (954) 584-4446 or toll
free (866) 584-5504.
• Do not attempt to jumpstart a frozen battery.
• Never submerge this unit in water.
BATTERY REPLACEMENT:
It is recommended to return unit to Vector® customer service for battery replace-
ment: contact (954) 584-4446 or toll free (866) 584-5504.
BATTERY DISPOSAL:
This unit contains a maintenance-free, sealed, non-spillable, lead acid battery which
must be disposed of properly. some states require recycling. Disposal questions? in
usa, call (877) 288-7722.