Viking InterWorks 1005294 - Manual (Page 12)

4 Hardware Installation
1. Locate an available USB port on your computer and connect it with
the USB cable on the back of the Viking IntelliFlash USB Flash Memory
Reader. This port is usually located on the back of your system. If you
are not familiar with the location of the USB ports on your computer,
please refer to your systems “Owner’s Guide” for detailed instructions.
Note: The Viking Components IntelliFlash USB Flash Memory Reader
must be connected to a USB port on your computer or to a powered
USB hub.
Your hardware setup is now complete. For information on how to use
the Viking IntelliFlash, proceed to the section “Using the Viking
IntelliFlash” on page 11.
Chapter 4 10
VIKING COMPONENTS INTELLIFLASH USB FLASH MEMORY READER USER’S GUIDE
5294bVCI 5/16/00 11:19 AM Page 12