Viking F1605G - Manual (Page 7)

13
Wok Cast Iron Burner (If applicable)
For proper lighting and performance of the burner, keep the electric
igniter and burner ports clean. It is necessary to clean these only when
the flame does not burn blue completely around all rings of the burner,
when there is a severe spillover or when the burner does not light, even
though the electric spark igniter sparks. Clean the burner by scraping off
burned on food soil. Use a wire, a straightened paper clip, or needle to
clean the ports. Do not use a toothpick; it could break off in the port. Be
sure the venturi tube remains dry.
Wok Pan w/Lid (If applicable)
Wash the wok after each use in hot, soapy water. Do not use harsh
abrasives or scouring pad as they can harm the protective seasoning.
Dry thoroughly. Apply a light coat of cooking oil to the inside surface
with a paper towel. Place over medium heat for 15 - 30 seconds.
Remove from heat and allow to cool. Wipe off excess oil before storing
in an inside cabinet. Do not store the wok pan and lid outdoors.
Orifice
Venturi tube
Burner
ports
Cleaning and Maintenance
Any piece of equipment works better and lasts longer when maintained
properly and kept clean. Cooking equipment is no exception. Your
rangetop must be kept clean and maintained properly. Make sure all
burners are “off” before cleaning. Disconnect power if you are going to
clean thoroughly with water.
12
Porcelain Parts (Grate and Grate Support)
Allow the grate and grate support to cool to a safe temperature level.
Wipe up spillovers as soon as possible after they occur and before they
get a chance to burn in and cook solid. The grate and grate support are
coated with a porcelain enamel finish for durability. Wash in hot, soapy
water and rinse clean. For stubborn stains, use a mild abrasive cleanser
or non-abrasive soap-filled pad. Abrasive cleaners used vigorously or too
often can eventually scratch and harm the enamel.
Control Panel
DO NOT USE any cleaners containing ammonia or abrasives. They could
remove the graphics from the control panel. Use hot, soapy water and a
soft clean cloth.
Control Knobs
MAKE SURE THE CONTROL KNOBS POINT TO THE OFF POSITION
BEFORE REMOVING. Pull the knobs straight off. Wash in detergent and
warm water. Do not soak knobs. Dry completely and replace by pushing
firmly onto stem. DO NOT USE any cleaners containing ammonia or
abrasives. They could remove the graphics from the knob.